三分PK拾

当前位置:三分PK拾-三分PK拾 > 三分PK拾

山东通风安装施工中的必备的知识

发布人:http://www.xoombulbs.com   发布时间:2017-07-18 15:21:32

1.管板材的开槽

三分PK拾Slotting of 1. tubes

板材开槽的种类有三种:一块板开槽法、二块板开槽法、四块板开槽法。板材开槽的方法有两种:手工开槽法、机械开槽法。

There are three kinds of slotted plates: one plate slotting method, two plate slotting method and four plate slotting method. There are two kinds of slotting methods: manual slotting method and mechanical slotting method.

2。密封

2. seal

节能消音通风管道系统建议使用的密封胶带有:热敏胶带、压敏胶带两种。在管道未用胶带密封前,应先使用专用的扒形装订针,对管道的搭接口进行固定,装订针的间距为50mm一个。装订时,装订针应与接缝略呈角度。装订针仅用于有盖舌的搭接口固定,若无盖舌,或平接口时,应用胶带接片进行固定,胶带最大为300mm,每边至少1个。

Energy saving silencer ventilation duct system recommended sealing tape: heat sensitive tape, pressure-sensitive adhesive tape two。 Before the pipe is sealed with adhesive tape, the special binding pin shall be used to fix the interface of the pipe, and the spacing of the binding needle is 50mm。 When binding, the binding pin should be slightly angled to the seam。 The staple is used only by the tongue cover interface is fixed, if there is no cap tongue or flat interface, application of fixed tape splicing tape, maximum 300mm, each side of at least 1。

QQ截图20170428145447.png

3.加固

三分PK拾3. reinforcement

当通风管道系统内部的静压负载使玻纤通风管道管道壁出现1%的挠度时,就需要对通风管道管道进行加固。通常节能消音通风管道系统管道可采用以下方法来进行加固:a.拉杆加固法,它是采用钢彩、套管加固,通常使用在500Pa以下的正压加固。b.框架加固法,即采用轻钢龙骨加固。c.抱合加固法,即采用轻钢龙骨加固,使用在拉杆加固和框架加固无法应用的某些特殊管道上,如900弯管、三通管、闷头管等。d.防下垂加固法,它用于特殊管道的加固,如变经管道加固和迂回管道加固。

When the static pressure of the ventilation duct system makes the 1% deflection of the glass fiber ventilation pipeline wall, it is necessary to reinforce the ventilation pipe and pipeline. Normally, energy-saving, silencing, ventilation, ductwork, piping can be strengthened by the following methods: A. tie bar reinforcement method, which is strengthened by steel color and casing, usually used under 500Pa reinforcement. B. frame reinforcement method, that is, the use of light steel keel reinforcement. C. cohesion reinforcement method, which uses light steel keel reinforcement reinforcement, using some special pipeline cannot be applied in strengthening and frame, such as 900, three elbow pipe and tube bulkhead. D. anti sagging reinforcing method used for reinforcement of special pipes, such as warp reinforcement and bypass reinforcement.

4.破损修补

4. damaged repair

如果是管道外表面很轻微的破损,可以用专用的密封胶带来进行修补即可。如果是管道内表面有轻微破损,则可用舒伯专用修补胶进行修补。如果管道外表面的铝箔层发生破损,而玻纤保温层未发生损坏,则可选用一片合格的铝箔片进行管道铝箔表面的修补。

If the outer surface of the pipe is slightly damaged, it can be repaired with a special sealed adhesive tape。 If there is a slight damage to the inner surface of the pipe, it can be repaired with special repair adhesive。 If the aluminum coating on the outer surface of the pipe is damaged and the glass fiber insulation layer is not damaged, a qualified aluminum foil can be used to repair the surface of the pipe foil。

如果管道壁的破损已达到玻纤保温层时,则可将破损的地方切割下来,开出雌雄搭接口,另选一块完好的板材,根据切割下来的玻板尺寸切割好,留下雌雄搭接口,在四周接口上涂上修补胶及粘胶剂,根据工艺规范进行密封。如果管道的破损比较严重,且破损面积比较大,有可能会影响通风管道系统的正常运行时,就需要对管道进行更换修补,以保证系统的正常运行。

三分PK拾If the damaged pipe wall of glass fiber insulation layer has been reached, it can be damaged areas cut out of a male and female interface, choose a block intact plate, according to the size of glass cut cut, leaving a female interface around the interface with the repair glue and adhesive seal, according to process specification. If the damage of the pipeline is serious and the damage area is relatively large, it may affect the normal operation of the ventilation pipe system, so it is necessary to replace and repair the pipe so as to ensure the normal operation of the system.

有了上面的小总结,希望对广大客户有所帮助,如果有什么不理解的或者寻求帮助的请点击我们的官方网站:山东通风管道http://www.xoombulbs.com/或者来电咨询,我们会尽全力为您解决

There is a small sum above, hope to help customers, if what you do not understand or seek help please click on our official website: Shandong ventilation pipeline http://www.xoombulbs.com/ or contact us, we will do our bfor you to solve

上一篇:济南通风管的使用维护的知识
下一篇:黑白铁加工产品在制作的特点

网站三分PK拾 关于我们 产品展示 三分PK拾 工程案例 在线留言 联系我们

极速快乐十分 澳洲幸运5登陆 天津11选5和值 重庆幸运农场网址 河北11选5 极速快3 北京快三预测 一分快三 极速飞艇注册 极速快三计划